Description
Inspect a mobile or tablet layout against grip-based thumb zones, hand occlusion and physical touch-target thresholds to flag misplaced, undersized or crowded controls.
This checklist inspection treats touch layout partly as industrial design. Phones are held one-handed (about 49%), cradled (36%) or two-handed (15%), and thumbs make about 75% of taps, so a comfortable arc sits at the bottom of the screen opposite the thumb; phablets, tablets and hybrids shift the zone to sides and corners. Frequent controls belong in the zone, destructive ones just outside, content above controls because the hand hides what is below, and feedback above the finger. Target size is checked in physical units: Microsoft data show miss rates of about 1 in 30 at 5 mm, 1 in 100 at 7 mm and 1 in 200 at 9 mm. Clark sets 7 mm (44 px, pt or dp) as the minimum, 9-11 mm for risky or out-of-zone targets, 10-15 mm for users with limited motor control, and 2 mm spacing between 7 mm targets.
Attributes
- Discipline
- Usability & Evaluation
- Loss type
- Vestigial
- Stage
- Design, Evaluation
- Data
- Analytical / expert
- Effort
- Hours
Steps
- List the device classes in scope and the grips used on each, from observation or published grip studies; design for the most constrained grip.
- Draw easy, stretch and hard thumb zones per grip and overlay them where devices or hands overlap.
- Check that frequent and primary controls sit in the shared easy zone and destructive or data-changing controls just outside it.
- Check hand occlusion: content and labels above controls, touch feedback above the finger, and no clashes with OS or browser toolbars.
- With the viewport set to device-width, list every target's size and spacing; flag targets under 44 x 44 px (7 mm), allowing 44 x 30 only where space forces it.
- Flag destructive or edge and corner targets under 57-69 px (9-11 mm), and 7 mm targets closer than 2 mm (13 px) apart.
- Raise sizes to 10-15 mm for audiences with limited motor control and report violations with recommended changes.
Sources
- Designing for Touch (Clark, 2015)
Also known as
- Grip and thumb-zone mapping
- Thumb-zone mapping
- Reach-zone audit
- Rule of thumb layout audit
- Content above controls check
- Touch target size and spacing audit
- Touch-target audit
- Tap target audit
- 44-pixel rule check
- 7 mm target check
Categories
- User Research
- Usability & Evaluation